About Us
Delivery Information
Pay Securely
Site Security
Site Terms
Cant find the item you require?

Plumbprice.comCall us free on 0800 0432419Free Delivery


BY TOTAL BATHROOMS - Tel: 01246 550199





Tips for working with Laminate Panels


When cutting the panels to width and height using a handsaw, the decorative face should be facing upwards.When cutting with a jigsaw or circular saw, the decorative face should be facing downwards.


A clearance of 2-3mm should be left where pipes or fittings come through the panel even where collars are to be fitted. The clearance should then be filled with Wetwall silicone sealant.


If a Wetseal is not being fitted then a 3-4mm gap should be left between the bottom of the panel and the shower tray or bath by using packers when fixing panels. The gaps should then be sealed using Wetwall silicone sealant. Wetwall silicone sealant should also be used in all the corner and capping profiles. See video below if using Wetseal kit.

Wall Surfaces

The panels can be fixed to most surfaces using adhesive, providing they are sound and free from loose particles.
The panels can also be fixed directly onto existing tiling providing they have been de-greased.


Fittings and shower attachments can be fixed directly to the panels using suitable fixings. Heavier items such as sanitary ware and accessible furniture will require the provision of additional support behind the panels.

Standard Installation

Two Sided Shower

1. Fit an internal corner profile into the corner using appropriate fixings (screws), ensuring that the heads are countersunk to prevent fouling when fitting the panel.

2. Remove the film from the face of the panel and check for defects prior to cutting to size.

3. Apply a bead of sealant into one side of the internal corner profile, the amount of sealant applied should cover the channel bottom to a depth of at least 2mm.

4. The panels should be fitted such that a gap is formed between the bottom of the panels and the shower tray of between 3-4mm this should be filed with sealant and cleaned off flush with the front of the panels once all the panels have been fitted. (If using a wetseal profile kit please refer to the instructions provided within kit - and refer to video below).

5. If end cap profiles are being used then these should be fitted to the outer edges of the panel now.

6. Apply a generous amount of adhesive in “snakes” to the panel and fit into place ensuring that the edge of the panel is inserted into the internal corner and a good seal achieved.

7. Repeat sections 2-6 for the second panel.


telephonePLEASE CALL US FREE OF CHARGE ON 0800 0432419 or STANDARD RATE 01246 550199

All items below are available delivered to site in two working days.  Please call our sales office for item and delivery prices.


Wetwall (Shore laminates) available in 590mm, 900mm and 1200mm Wide sheets.  2420mm High, 11mm thick.

Comes complete with manufacturers lifetime guarantee.

All other Shore Laminate products which aren't such as acrylic panels are available as special order please call for details.





Panels are supplied in three different width options:-

    585mm wide with Tongue and Groove joints on long edges
    900mm wide with square edges
    1200mm wide with square edges

All our panels are 2400mm high.

For single wall formats - all widths greater than 1200mm will be supplied as 585mm wide panels with Tongue and Groove joints on long edges.

By completing the drop down boxes below, the correct panel configurations will be calculated automatically. All you need to do is measure the corresponding wall widths and select the size that is the closest (but higher) than your measurement.

Note: It will always be necessary to cut the panels when fitting. We provide comprehensive fixing guidance to help you through this process.

If your sizes do not correspond with our options below, please contact us so
that we can assist you with your order.